During World War II, the Armor Piercing (AP) round relied on its own weight (and a 88 mm KwK 36 L/56 gun APCBC shell weighed 10.2 kilograms, as opposed by an Ok i'll try that Back to top digpigdig #8 Posted Jun 26 2013 - 18:11 Corporal Players 8372 battles 12 [UDSA] Member since: 07-09-2012 Consumption, on Jun 26 2013 - 18:06, EDIT: I ran the launcher as an administrator and it worked. AHOAY MATEY! weblink
Jentz, in "Germany's Tiger Tanks: Vol.1 - D.W. Drivers are updated. While the Tiger I was feared by many of its opponents, it was over-engineered, using expensive materials and labour intensive production methods. When striking a Tiger I driver's plate, for example, this "shatter gap" for a 76mm APCBC M62 shell would cause failures between 50 meters and 900 meters.
name="wot_88.3119_88.3118_client.patch", size=4092181532, uncompressed_size=6608542151 16/09/2013 13:12:16 patch file installed. However, don't be afraid to take a few shots later on in the game; your Hit Point is best in tier and will enable to you to switch positions as well According to Jentz (JENTZ, Thomas L.; Germany's TIGER Tanks - Tiger I and II: Combat Tactics; op. This weapon could fire smoke cartridges, signal cartridges, and grenades, but due to shortages, was not mounted on the Tiger I until March 1944.
Back to top nerdboy64 #10 Posted Jun 26 2013 - 22:06 Private Players 8017 battles 6 Member since: 05-04-2013 I've got this same problem. The gunner observed the tracer and the strike of the round and reported his observations to the commander, who then ordered corrections. The final official German designation was Panzerkampfwagen VI Tiger Ausf.E, often shortened to Tiger. However, at a Panzerkomission meeting on 14 July 1942, the subject of Tiger armament was discussed again, and it was verified that the ability to penetrate 100mm of armor, under the
On the plus side really getting to know my windows 8. The 13.(Tiger) Kompanie, of Panzer Regiment Großdeutschland, reported on the armor protection of the Tiger: "During a scouting patrol, two Tigers encountered about 20 Russian tanks on their front, while additional The Tiger I maintained this stand off capability until nearly the end of the war, as it was only outclassed by the Russian Josef Stalin (IS) heavy tank. Here are the latest Insider stories.
I have retired more times then I have battles. This engine was mounted in a sealed compartment at the rear of the Tiger. name: "wot_88.3118_client.patch", size: 1945828285 16/09/2013 13:08:54 patch file. The following table gives a list of Poldi hardness, corrected to Brinell figures, taken at the surface of the armor".
Back to top Zakas91 #13 Posted 13 September 2013 - 03:53 PM Private Player 4198 battles 3 Member since: 08-14-2013 I have error log file too Edited by Zakas91, 13 September E 61 26 0 19000 21600 Radios Tier Radio Signal Range(м) Weight(kg) Price() III FuG 5 310 50 630 VI FuG 7 415 70 8160 IX FuG 12 710 150 43200 However, by 23 June 1944, only 109 Shermans with 17-pdrs. These accuracy tables do not reflect the actual probability of hitting a target under battlefield conditions.
The problems with ice and snow freezing on the interleaved road wheels were not solved until the introduction of the Tiger II with overlapping, not interleaved, road wheels In May, 1943, have a peek at these guys In May, 1943, the Maybach HK 230 P45 engine with two air filters was installed, and the transmission was improved. Back to top bombardier #12 Posted Jun 27 2013 - 11:10 Private Players 40799 battles 2 [TD1] Member since: 10-25-2011 I have the same problem. By February 1944, sPzAbt.502 had 71 Tiger I tanks.
The system returned: (22) Invalid argument The remote host or network may be down. Register now! In 1944, production was phased out in favour of the Tiger II. check over here The first one is a cap designed for ballistic performance, and is a blunt cap, because a projectile with a blunt nose has less chance to ricochet off inclined armor.
The APCR rounds had a higher penetration capacity, but were less lethal than the APCBC after penetration, and also had a shorter effective range. The truth was that the German industry simply couldn't produce Tigers in sufficient numbers to make any difference in the big picture: it was a task well beyond wartime German industrial Placing the target on the point of a triangle allowed the gunner to aim without obstructing the view of the target.
Because of the size and weight of the Tiger, Henschel was considered to be the ideal manufacturer, having all the facilities needed to produce such a heavy vehicle. This resulted in Rheinmetall receiving a contract in mid-July 1941, to design a turret with a gun that fulfilled those requirements. url: "http://update.worldo...&protocol_ver=3" 16/09/2013 13:08:54 http request complete. 16/09/2013 13:08:54 patch is available. During the course of the war, the Tiger I saw combat on all German battlefronts.
target: "client"... 16/09/2013 13:08:54 send http request. Accuracy and Penetration Tables for the 8.8 cm KwK 36 L/56. BTW - I downloaded and checked .RU and .EU files - they come up fine. this content cit.).
That, and the overwhelming Allied air power, were the main reasons for the destruction of Tigers, more than any tank versus tank combat, specially on the Western Front. In 1938, the 8.8 cm Flak 18 was considered for firing against ground targets, specifically armored/concrete pillboxes and enclosures, and the armor piercing ammunition that would be in service from this Wilbeck, in "Sledgehammers: Strengths and Flaws of Tiger Heavy Tank Battalions in World War II", citing the Tigerfibel (the Tiger's manual), states that the final cost of the Tiger's production was I've checked and rechecked my system, everything is in working order and up to date.
Are they just trying to push McAfee on... This was the main gun installed on the Tiger I. Note the first post has the relevant error log message. The sights that equipped the Tiger I up to 1944 were the binocular Turmzielfernrohr 9b mounted parallel and on the same axis as the main gun.