Home > Error Codes > Wrg Atm Tamper Error

Wrg Atm Tamper Error

Contents

Your cache administrator is webmaster. Purge the dispenser with the purge command under diagnostics. Verify that the identity of each cassette can be read through read cassette ID function (See the 5000 Cash Dispenser Configuration Manual). Install the reject vault.

Complete several test dispenses. Replace the power supply or dispenser DC power if either is defective. 3. When the note is stuck in the note transport sensor. 2. Verify all connectors to the dispenser mechanism.

Wrg Atm Manual

Clear the error. If the cash dispenser operates normally put it in service. Make sure that note qualifier and the note transport modules are mechanically aligned. Verify that all DC voltages applied to the printer control board are correct.

  1. Remove and fill the affected cassette using normal procedures.
  2. Clear terminal error code.
  3. Perform several test dispenses.

Legendary kevin 7,827 views 0:55 How to Make an ATM Spew Out Money - Duration: 3:04. If a belt displays excessive wear or damage you may be able to replace it. If the problem persists; replace the dispenser. (see error 37 above for step by step diagnostics) 39 (27h) Too many notes Clean the all sensors. Triton Error Codes Test the dispenser by completing several test dispenses.

Verify that all access panels are closed and secured. This error will place the cash dispenser ìOut of Serviceî. Inspect the note feeders and note qualifier for damage. Dispenser failed to identify the dispenser type installed.

A defective cassette may also cause this problem. 333(51h)[Q] Reject vault full. Triton Atm Loading... If replacing the modem does not correct the problem; replace the main board. 138 Print failure while printing to the receipt printer. Refer to error 522. 528 EJ sequence error.

Wrg Atm Error Codes

If error persists; replace the dispenser mechanism. 387 Dispenser offline ñ error validating configuration. Inspect all cables for damage. Wrg Atm Manual If the error clears; put the cash dispenser in service. 3. Atm Error Codes List Verify that the power supply is operating and the DC voltages being supplied to the main board and dispenser are correct.

Time-out waiting for response or carrier was dropped. If error persists; replace the dispenser mechanism. 369 Dispenser device reset. Starting at the top; you should find 24 volts; -12 volts; no pin; 5 volts; ground; 5 volts and ground. Modem may be defective. (If problem persists call Your Service Provider or Triton Tech Support) 6 BGD_NODIALTONE No money is dispensed; screen and receipt display system unavailable. 1. Hyosung Atm Error Codes

Clear all errors and test the dispenser with a live transaction. Replace the dispenser is the error persists. 358 Dispenser device read error. Restart operating system. Sign in to report inappropriate content.

Open the printer and verify that there are no jams in the printer or the paper path. If these actions have no effect on dispenser operation; replace the dispenser mechanism. 115 (73h) Diverter timeout on purge 1. If the problem persists contact WRG Technical Support   4016 Note missing at the double detect (dispenser) (The double detect failed to detect a bill, which has been identified by the

If error persists; replace the dispenser mechanism. 372 Dispenser item value error Clear terminal error code.

This error code is produced when the single reject event counter exceeds 50 reject events or the bundle reject event counter exceeds 250 notes. Refer to error 500. 505 SPED device busy. Inspect cable from Main Board assembly to the SPED module for damage. If the problem persists; replace the dispenser.

Clear any jammed currency. 2. Refer to error 522. 534 EJ device reset. Reset the cash dispenser and clear the error. If the error recurs; change the note feeder for the affected channel. 320(44h)[D] Reject cassette almost full.

Petersburg Grand Prix Fairshares ATM solved all my ATM problems and keep my customers happy with there quick responses. Remove jammed currency. 2. Replace the dispenser is the error persists. 360 Dispenser invalid return ID. Inspect for jammed currency at the Exit.

Loading... Restart the operating system. If the problem persists; replace the dispenser. 50 (32h) Interference recovery Possible static discharge. If the error clears put the cash dispenser into service.

Used up all radial attempts and got No Dial Tone for each attempt. 2. Clear the terminal error code. Enter a smaller value. If the error code is reported again; replace the CMC module. 309(39h)[9] Jam in Note Qualifier.

It the status clears; place the cash dispenser in service. Inspect the cable supplying DC power from the power supply to the printer.